Question

Copper of fixed volume $$V$$ is drawn into wire of length $$l.$$ When this wire is subjected to a constant force $$F,$$ the extension produced in the wire is $$\Delta l.$$  Which of the following graphs is a straight line?

A. $$\Delta l\,versus\,\frac{1}{l}$$
B. $$\Delta l\,versus\,{l^2}$$  
C. $$\Delta l\,versus\,\frac{1}{{{l^2}}}$$
D. $$\Delta l\,versus\,l$$
Answer :   $$\Delta l\,versus\,{l^2}$$
Solution :
Youngs’ modulus is given by $$Y = \frac{{F \times l}}{{A \times \Delta l}}\,.....\left( {\text{i}} \right)$$
As, $$V = A \times l = {\text{constant}}\,.....\left( {{\text{ii}}} \right)$$
From Eqs. (i) and (ii), we get
$$\eqalign{ & Y = \frac{{F \times {l^2}}}{{V \times \Delta l}} \Rightarrow \Delta l = \frac{F}{{V \times Y}} \times {l^2} \cr & \Rightarrow \Delta l \propto {l^2} \cr} $$

Releted MCQ Question on
Basic Physics >> Mechanical Properties of Solids and Fluids

Releted Question 1

The following four wires are made of the same material. Which of these will have the largest extension when the same tension is applied?

A. $$length=50\,cm, \,\,diameter=0.5 \,mm$$
B. $$length = 100 \,cm, \,\,diameter= 1 \,mm$$
C. $$length= 200 \,cm, \,\,diameter= 2 \,mm$$
D. $$length=300 \,cm, \,\,diameter =3 \,mm$$
Releted Question 2

A U-tube of uniform cross section (see figure) is partially filled with a liquid I. Another liquid II which does not mix with liquid I is poured into one side. It is found that the liquid levels of the two sides of the tube are the same, while the level of liquid I has risen by $$2 \,cm.$$  If the specific gravity of liquid I is $$1.1,$$  the specific gravity of liquid II must be-
Mechanical Properties of Solids and Fluids mcq question image

A. $$1.12$$
B. $$1.1$$
C. $$1.05$$
D. $$1.0$$
Releted Question 3

A homogeneous solid cylinder of length $$L\left( {L < \frac{H}{2}} \right),$$   cross-sectional area $$\frac{A}{5}$$ is immersed such that it floats with its axis vertical at the liquid-liquid interface with length $$\frac{L}{4}$$ in the denser liquid as shown in the figure. The lower density liquid is open to atmosphere having pressure $${P_0}.$$ Then density $$D$$ of solid is given by-
Mechanical Properties of Solids and Fluids mcq question image

A. $$\frac{5}{4}d$$
B. $$\frac{4}{5}d$$
C. $$4d$$
D. $$\frac{d}{5}$$
Releted Question 4

A large open tank has two holes in the wall. One is a square hole of side $$L$$ at a depth $$y$$ from the top and the other is a circular hole of radius $$R$$ at a depth $$4y$$  from the top. When the tank is completely filled with water, the quantities of water flowing out per second from both holes are the same. Then, $$R$$ is equal to-

A. $$\frac{L}{{\sqrt {2\pi } }}$$
B. $$2\pi L$$
C. $$L$$
D. $$\frac{L}{{2\pi }}$$

Practice More Releted MCQ Question on
Mechanical Properties of Solids and Fluids


Practice More MCQ Question on Physics Section